BMCables INPA problems

[Ollie Campbell 4]

 

Hi guys,

 

I’ve got a BMCables diagnostic cable that I've had for a while and haven’t had any problems with it in the past. I’ve just needed to use it on a new car (2009 E61) and can’t seem to get it working, I’m getting an IFH-0009 error running INPA.

 

Using:

• Windows 10 64-bit
• Windows XP 32-bit
• Windows XP 64-bit

 

Have tried:

 

• AV & firewall off for installation and running the software.
• Running Windows without driver signature verification enabled.
• The red light is on the cable
• INPA is showing a black dot for battery and ignition
• The cars ignition is definitely on
• Used the DCAN software to make sure the cable is set to K-line mode
• OBDSetup.exe comes back OK
• Switch on silver cable to left hand side.
• FTDI drivers were installed

• The cable shows up as a ‘BMcables diagnostic cable’ using driver 16/08/2017 v2.12.28.0 in Device Manager.
• Using the BimmerWorld (I think) version of INPA

 

 

Can anyone provide any pointers?

 

Edited January 11 by Ollie Campbell