Jameswsb 38 Report post Posted February 28, 2017 Jimmy - for some reason the INPA cable/software will not recognise when the ignition is switched on. The light on the cable is on but I cant access to read fault codes. Please help! Share this post Link to post Share on other sites
jimmy 311 Report post Posted February 28, 2017 check your using correct usb port. Share this post Link to post Share on other sites
Jameswsb 38 Report post Posted March 1, 2017 Yeah already done that. I have recently added Office to the laptop but that shouldnt change anything surely? anything else i should check? Cheers Share this post Link to post Share on other sites
jimmy 311 Report post Posted March 2, 2017 so when the cable is plugged in, device manager reports it as usb serial port com1? Share this post Link to post Share on other sites
Jameswsb 38 Report post Posted March 8, 2017 It says COM3 Share this post Link to post Share on other sites
Jameswsb 38 Report post Posted March 8, 2017 Should I select COM1 and set up the latency timer? I cant remember how many seconds that was? Cheers Share this post Link to post Share on other sites
jimmy 311 Report post Posted March 9, 2017 com1 and latency down to 1, make sure you use same usb port when you use it. Share this post Link to post Share on other sites
Jameswsb 38 Report post Posted March 13, 2017 All sorted, thanks Jimmy Share this post Link to post Share on other sites